Carving Copier 2.0

Carving Copier 2.0

Jul 15

 

Well, it’s been a while since my last post.

 

Been working on some big things in the shop and it’s too early to reveal any details.

 

To get ready, though, I resurrected the carving copier I built a few years back.

 

This is version 2.0 which I replaced the drawer slides (X axis) on the original with linear bearings and rails (20 mm X 30 inches) like I used on the Z and Y axis.

 

 

 

 

 

This improvement makes the copier much smoother, dead on accurate, and gets rid of the racking issue I had with the drawer slides.